Bar (unit)
bar | |
---|---|
![]() A pressure of 700 bar flattened this length of aluminium tubing, which had a wall thickness of 5 millimetres (0.20 in). | |
General information | |
Unit system | Metric system |
Unit of | pressure |
Symbol | bar |
Conversions | |
1 bar in ... | ... is equal to ... |
atm |
The bar is a metric unit of pressure defined as 100,000 Pa (100 kPa), though not part of the International System of Units (SI). A pressure of 1 bar is slightly less than the current average atmospheric pressure on Earth at sea level (approximately 1.013 bar).[1][2] By the barometric formula, 1 bar is roughly the atmospheric pressure on Earth at an altitude of 111 metres at 15 °C.
The bar and the millibar were introduced by the Norwegian meteorologist
The
Units derived from the bar include the megabar (symbol: Mbar), kilobar (symbol: kbar), decibar (symbol: dbar), centibar (symbol: cbar), and millibar (symbol: mbar).
Definition and conversion
The bar is defined using the SI derived unit, pascal: 1 bar ≡ 100,000 Pa ≡ 100,000 N/m2.
Thus, 1 bar is equal to:
- 1,000,000 Ba (cgs units);
and 1 bar is approximately equal to:
- 0.98692327 atm
- 14.503774 psi
- 29.529983 inHg
- 750.06158 mmHg
- 750.06168 Torr
- 1019.716 centimetres of water (cmH2O) (1 bar approximately corresponds to the gauge pressure of water (not absolute) at a depth of 10 meters).
Notes:
- 1 millibar (mbar) = 1 one-thousandth bar, or 1×10−3 bar
- 1 millibar = 1 hectopascal (1 hPa = 100 Pa).
Origin
The word bar has its origin in the Ancient Greek word βάρος (baros), meaning weight. The unit's official symbol is bar;[citation needed] the earlier symbol b is now deprecated and conflicts with the uses of b denoting the unit barn or bit, but it is still encountered, especially as mb (rather than the proper mbar) to denote the millibar. Between 1793 and 1795, the word bar was used for a unit of weight in an early version of the metric system.[6]
Usage
![](http://upload.wikimedia.org/wikipedia/commons/thumb/a/ac/Day5pressureforecast.png/220px-Day5pressureforecast.png)
In fresh water, there is an approximate numerical equivalence between the change in pressure in decibars and the change in depth from the water surface in metres. Specifically, an increase of 1 decibar occurs for every 1.019716 m increase in depth. In sea water with respect to the gravity variation, the latitude and the geopotential anomaly the pressure can be converted into metres' depth according to an empirical formula (UNESCO Tech. Paper 44, p. 25).[11] As a result, decibars are commonly used in oceanography.
In scuba diving, bar is also the most widely used unit to express pressure, e.g. 200 bar being a full standard scuba tank, and depth increments of 10 metre of seawater being equivalent to 1 bar of pressure.
Many engineers worldwide use the bar as a unit of pressure because, in much of their work, using pascals would involve using very large numbers. In measurement of
Pressures resulting from deflagrations are often expressed in units of bars.[12]
In the automotive field, turbocharger boost is often described in bars outside the United States. Tire pressure is often specified in bars. In hydraulic machinery components are rated to the maximum system oil pressure, which is typically in hundreds of bars. For example, 300 bars is common for industrial fixed machinery.
In the maritime ship industries, pressures in piping systems, such as cooling water systems, is often measured in bars.
Unicode has characters for "mb" (U+33D4 ㏔ SQUARE MB SMALL) and "bar" (U+3374 ㍴ SQUARE BAR), but they exist only for compatibility with legacy Asian encodings and are not intended to be used in new documents.
The kilobar, equivalent to 100 MPa, is commonly used in geological systems, particularly in experimental petrology.
The abbreviations "bar(a)" and "bara" are sometimes used to indicate absolute pressures, and "bar(g)" and "barg" for gauge pressures. The usage is deprecated but still prevails in the oil industry (often by capitalized "BarG" and "BarA"). There exists no conversion between "BarG" and "BarA" for atmospheric pressure changes from time to time with a range of change about 50 mBar. Fuller descriptions such as "gauge pressure of 2 bars" or "2-bar gauge" are recommended.[2][13]
See also
- Centimetre or millimetre of water
- Conversion of units § Pressure or mechanical stress
- List of metric units
- Metric prefix
- Orders of magnitude (pressure) § 100kPa
References
- This article incorporates material from the Creative Commons Attribution-ShareAlike 3.0 Unported License but not under the GFDL.
- ^ ISBN 978-92-822-2272-0.
- ^ British StandardBS 350:2004 Conversion Factors for Units.
- ^ "Nomenclature of the unit of absolute pressure, Charles F. Marvin, 1918" (PDF). noaa.gov. Archived (PDF) from the original on 29 April 2017. Retrieved 6 May 2018.
- ^ NIST Special Publication 1038 Archived 2016-03-19 at the Wayback Machine, Sec. 4.3.2; NIST Special Publication 811, 2008 edition Archived 2016-06-03 at the Wayback Machine, Sec. 5.2
- ^ International Astronomical Union Style Manual. Comm. 5 in IAU Transactions XXB, 1989, Table 6
- ^ Grave (unit)
- ^ Canada, Environment (2013-04-16). "Canadian Weather at a Glance - Environment Canada". www.weatheroffice.gc.ca. Archived from the original on 2 January 2018. Retrieved 6 May 2018.
- ^ Canada, Environment (2013-04-16). "Canadian Weather - Environment Canada". www.weatheroffice.gc.ca. Archived from the original on 2 January 2018. Retrieved 6 May 2018.
- ^ US government atmospheric pressure map
- ^ The Weather Channel
- ^ Scientific Committee on Oceanic Research (1983). "Algorithms for computation of fundamental properties of seawater" (PDF). Archived (PDF) from the original on 2015-04-12. Retrieved 2014-05-11.
- ^ NFPA 68 Standard on Explosion Protection by Deflagration Venting (2023 ed.).
- ^ "What do the letters 'g' and 'a' denote after a pressure unit? (FAQ - Pressure) : FAQs : Reference : National Physical Laboratory". Archived from the original on 7 April 2016. Retrieved 7 February 2016.
External links
- Official SI website: Table 8. Non-SI units accepted for use with the SI
- US government atmospheric pressure map showing atmospheric pressure in mbar
Pascal | Bar | Technical atmosphere
|
Standard atmosphere | Torr | Pound per square inch
| |
---|---|---|---|---|---|---|
(Pa) | (bar) | (at) | (atm) | (Torr) | (lbf/in2) | |
1 Pa | — | 1 Pa = 10−5 bar | 1 Pa = 1.0197×10−5 at | 1 Pa = 9.8692×10−6 atm | 1 Pa = 7.5006×10−3 Torr | 1 Pa = 0.000145037737730 lbf/in2 |
1 bar | 105 | — | = 1.0197 | = 0.98692 | = 750.06 | = 14.503773773022 |
1 at | 98066.5 | 0.980665 | — | 0.9678411053541 | 735.5592401 | 14.2233433071203 |
1 atm | ≡ 101325 | ≡ 1.01325 | 1.0332 | — | 760 | 14.6959487755142 |
1 Torr | 133.322368421 | 0.001333224 | 0.00135951 | 1/760 ≈ 0.001315789 | — | 0.019336775 |
1 lbf/in2 | 6894.757293168 | 0.068947573 | 0.070306958 | 0.068045964 | 51.714932572 | — |