Waste heat

Source: Wikipedia, the free encyclopedia.

Thermal oxidizers can use a regenerative process
for waste heat from industrial systems.
Air conditioning units extract heat from a dwelling interior with coolant, and transfer it to the dwelling exterior as waste. They emit additional heat in their use of electricity to power the devices that pass heat to and from the coolant.

Waste heat is heat that is produced by a machine, or other process that uses energy, as a byproduct of doing work. All such processes give off some waste heat as a fundamental result of the laws of thermodynamics. Waste heat has lower utility (or in thermodynamics lexicon a lower exergy or higher entropy) than the original energy source. Sources of waste heat include all manner of human activities, natural systems, and all organisms, for example, incandescent light bulbs get hot, a refrigerator warms the room air, a building gets hot during peak hours, an internal combustion engine generates high-temperature exhaust gases, and electronic components get warm when in operation.

Instead of being "wasted" by release into the ambient environment, sometimes waste heat (or cold) can be used by another process (such as using hot engine coolant to heat a vehicle), or a portion of heat that would otherwise be wasted can be reused in the same process if make-up heat is added to the system (as with heat recovery ventilation in a building).

Thermal energy storage, which includes technologies both for short- and long-term retention of heat or cold, can create or improve the utility of waste heat (or cold). One example is waste heat from air conditioning machinery stored in a buffer tank to aid in night time heating. Another is seasonal thermal energy storage (STES) at a foundry in Sweden. The heat is stored in the bedrock surrounding a cluster of heat exchanger equipped boreholes, and is used for space heating in an adjacent factory as needed, even months later.[1] An example of using STES to use natural waste heat is the Drake Landing Solar Community in Alberta, Canada, which, by using a cluster of boreholes in bedrock for interseasonal heat storage, obtains 97 percent of its year-round heat from solar thermal collectors on the garage roofs.[2][3] Another STES application is storing winter cold underground, for summer air conditioning.[4]

On a biological scale, all organisms reject waste heat as part of their metabolic processes, and will die if the ambient temperature is too high to allow this.

Anthropogenic waste heat can contribute to the urban heat island effect.[5] The biggest point sources of waste heat originate from machines (such as electrical generators or industrial processes, such as steel or glass production) and heat loss through building envelopes. The burning of transport fuels is a major contribution to waste heat.

Conversion of energy

See also: Second law of thermodynamics

Machines

electric energy
produce heat as a by-product.

Sources

In the majority of energy applications, energy is required in multiple forms. These energy forms typically include some combination of:

oil refineries and steelmaking plants.[citation needed
]

Air conditioning

Conventional air conditioning systems are a source of waste heat by releasing waste heat into the outdoor ambient air whilst cooling indoor spaces. This expelling of waste heat from air conditioning can worsen the urban heat island effect.[5] Waste heat from air conditioning can be reduced through the use of passive cooling building design and zero-energy methods like evaporative cooling and passive daytime radiative cooling, the latter of which sends waste heat directly to outer space through the infrared window.[6][7]

Power generation

The

thermal power plants is defined as the ratio between the input and output energy. It is typically only 33% when disregarding usefulness of the heat output for building heat.[8] The images show cooling towers
which allow power stations to maintain the low side of the temperature difference essential for conversion of heat differences to other forms of energy. Discarded or "Waste" heat that is lost to the environment may instead be used to advantage.

A coal-fired power station. These transform chemical energy into 36–48% electricity and the remaining 52–64% to waste heat.

Industrial processes

Industrial processes, such as

glass making are major sources of waste heat.[9]

Electronics

Although small in terms of power, the disposal of waste heat from

heatsinks
, etc. to dispose of the heat.

For example, data centers use electronic components that consume electricity for computing, storage and networking. The French

CNRS explains a data center is like a resistor and most of the energy it consumes is transformed into heat and requires cooling systems.[10]

Biological

Humans, like all animals, produce heat as a result of

sweating and panting. Fiala et al. modelled human thermoregulation.[11]

Cooling towers evaporating water at Ratcliffe-on-Soar Power Station, United Kingdom

Disposal

Low temperature heat contains very little capacity to do work (Exergy), so the heat is qualified as waste heat and rejected to the environment. Economically most convenient is the rejection of such heat to water from a sea, lake or river. If sufficient cooling water is not available, the plant can be equipped with a cooling tower or air cooler to reject the waste heat into the atmosphere. In some cases it is possible to use waste heat, for instance in district heating systems.

Uses

Conversion to electricity

There are many different approaches to transfer thermal energy to electricity, and the technologies to do so have existed for several decades.

An established approach is by using a

Seebeck effect
.

A related approach is the use of thermogalvanic cells, where a temperature difference gives rise to an electric current in an electrochemical cell.[13]

The

working medium instead of water. The benefit is that this process can reject heat at lower temperatures for the production of electricity than the regular water steam cycle.[14] An example of use of the steam Rankine cycle is the Cyclone Waste Heat Engine
.

Cogeneration and trigeneration

Waste of the by-product heat is reduced if a

trigeneration
or CCHP (combined cooling, heat and power).

District heating

Waste heat can be used in district heating. Depending on the temperature of the waste heat and the district heating system, a heat pump must be used, to reach sufficient temperatures. An easy and cheap way to use waste heat in cold district heating systems, as these are operated at ambient temperatures and therefore even low-grade waste heat can be used without needing a heat pump at the producer side.[15]

Pre-heating

Waste heat can be forced to heat incoming fluids and objects before being highly heated. For instance outgoing water can give its waste heat to incoming water in a

power plants
.

Anthropogenic heat

Anthropogenic heat is heat generated by humans and human activity. The American Meteorological Society defines it as "Heat released to the atmosphere as a result of human activities, often involving combustion of fuels. Sources include industrial plants, space heating and cooling, human metabolism, and vehicle exhausts. In cities this source typically contributes 15–50 W/m2 to the local heat balance, and several hundred W/m2 in the center of large cities in cold climates and industrial areas."[16] In 2020, the overall anthropogenic annual energy release was 168,000 terawatt-hours; given the 5.1×1014 m2 surface area of Earth, this amounts to a global average anthropogenic heat release rate of 0.04 W/m2.[17][18]

Environmental impact

Anthropogenic heat is a small influence on rural temperatures, and becomes more significant in dense

anthropogenic heat
by this definition.

Anthropogenic heat is a much smaller contributor to

global warming than greenhouse gases are.[20] In 2005, anthropogenic waste heat flux globally accounted for only 1% of the energy flux created by anthropogenic greenhouse gases. The heat flux is not evenly distributed, with some regions higher than others, and significantly higher in certain urban areas. For example, global forcing from waste heat in 2005 was 0.028 W/m2, but was +0.39 and +0.68 W/m2 for the continental United States and western Europe, respectively.[21]

Although waste heat has been shown to have influence on regional climates,

climate forcing from waste heat is not normally calculated in state-of-the-art global climate simulations. Equilibrium climate experiments show statistically significant continental-scale surface warming (0.4–0.9 °C) produced by one 2100 AHF scenario, but not by current or 2040 estimates.[21] Simple global-scale estimates with different growth rates of anthropogenic heat[23] that have been actualized recently[24] show noticeable contributions to global warming, in the following centuries. For example, a 2% p.a. growth rate of waste heat resulted in a 3 degree increase as a lower limit for the year 2300. Meanwhile, this has been confirmed by more refined model calculations.[25]

A 2008 scientific paper showed that if anthropogenic heat emissions continue to rise at the current rate, they will become a source of warming as strong as GHG emissions in the 21st century.[26]

See also

References

  1. ^ Andersson, O.; Hägg, M. (2008), "Deliverable 10 - Sweden - Preliminary design of a seasonal heat storage for IGEIA – Integration of geothermal energy into industrial applications Archived 11 April 2020 at the Wayback Machine, pp. 38–56 and 72–76, retrieved 21 April 2013
  2. ^ Wong, Bill (June 28, 2011), "Drake Landing Solar Community" Archived 2016-03-04 at the Wayback Machine, IDEA/CDEA District Energy/CHP 2011 Conference, Toronto, pp. 1–30, retrieved 21 April 2013
  3. ^ Wong B., Thornton J. (2013). Integrating Solar & Heat Pumps. Archived 2013-10-15 at the Wayback Machine Renewable Heat Workshop.
  4. ^ Paksoy, H.; Stiles, L. (2009), "Aquifer Thermal Energy Cold Storage System at Richard Stockton College" Archived 2014-01-12 at the Wayback Machine, Effstock 2009 (11th International) - Thermal Energy Storage for Efficiency and Sustainability, Stockholm.
  5. ^ a b Kovats, Sari; Brisley, Rachel (2021). Betts, R.A.; Howard, A.B.; Pearson, K.V. (eds.). "Health, Communities and the Built Environment" (PDF). The Third UK Climate Change Risk Assessment Technical Report. Prepared for the Climate Change Committee, London: 38. Although uptake may increase autonomously in the future, relying on air conditioning to deal with the risk is a potentially maladaptive solution, and it expels waste heat into the environment - thereby enhancing the urban heat island effect.
  6. S2CID 251420566
    – via Elsevier Science Direct. One such promising alternative is radiative cooling, which is a ubiquitous process of losing surface heat through thermal radiation. Instead of releasing waste heat into ambient air as conventional cooling systems, radiative cooling passively discharges it into outer space.
  7. S2CID 235790365
    – via Elsevier Science Direct.
  8. ^ "Annual Electric Generator Report". U.S. Energy Information Administration. 1 January 2018.
  9. doi:10.1016/j.applthermaleng.2021.117291
    .
  10. ^ "New Technologies' Wasted Energies". CNRS News. Retrieved 6 July 2018.
  11. S2CID 5751821
    .
  12. doi:10.1016/j.applthermaleng.2021.117291
    .
  13. S2CID 120138941
    .
  14. doi:10.1016/j.rser.2013.01.028. Archived
    from the original on 3 October 2016. Retrieved 7 May 2018.
  15. doi:10.1016/j.rser.2018.12.059
  16. ^ "Glossary of Meteorology". AMS. Archived from the original on 26 February 2009.
  17. ^ Ritchie, Hannah; Roser, Max; Rosado, Pablo (27 October 2022). "Energy Production and Consumption". Our World in Data. Retrieved 24 March 2023.
  18. ^ "What is the Surface Area of the Earth?". Universe Today. 11 February 2017. Retrieved 24 March 2023.
  19. ^ "Heat Island Effect: Glossary". United States Environmental Protection Agency. 2009. Archived from the original on 20 April 2009. Retrieved 6 April 2009.
  20. doi:10.1002/2015GL063514
    .
  21. ^
    S2CID 8371380
    .
  22. doi:10.1029/2004GL019852. Archived from the original on 6 June 2011.{{cite journal}}: CS1 maint: multiple names: authors list (link
    )
  23. ISSN 0043-6917, Bd. 19 (1973, H.2), 37-52. (online
    ).
  24. ISBN 978-3-939473-50-3
    .
  25. doi:10.1029/2008eo280001
    .
  26. arXiv:0811.0476
    .
Retrieved from "https://en.wikipedia.org/w/index.php?title=Waste_heat&oldid=1228647307"